|Dyxa.com - Document Archive|
|Manual Pages FAQs HOWTOs|
SAFESection: Devices and Network Interfaces (4)
Index Return to Main Contents
NAMEsafe - SafeNet crypto accelerator
DESCRIPTIONThe sysctl Va hw.safe.debug driver supports cards containing SafeNet crypto accelerator chips.
On all models, the driver registers itself to provide random data to the random(4) subsystem. Periodically the driver will poll the hardware RNG and retrieve data for use by the system. If the driver detects that the hardware RNG is resonating with any local signal, it will reset the oscillators that generate random data. Three sysctl(8) settings control this procedure: hw.safe.rnginterval specifies the time, in seconds, between polling operations, hw.safe.rngbufsize specifies the number of 32-bit words to retrieve on each poll, and hw.safe.rngmaxalarm specifies the threshold for resetting the oscillators.
When the driver is compiled with SAFE_DEBUG defined, two sysctl(8) variables are provided for debugging purposes: hw.safe.debug can be set to a non-zero value to enable debugging messages to be sent to the console for each cryptographic operation, hw.safe.dump is a write-only variable that can be used to force driver state to be sent to the console. Set this variable to ``ring '' to dump the current state of the descriptor ring, to ``dma '' to dump the hardware DMA registers, or to ``int '' to dump the hardware interrupt registers.
HARDWAREThe sysctl Va hw.safe.debug driver supports cards containing any of the following chips:
SEE ALSOcrypt(3), crypto(4), intro(4), ipsec(4), random(4), crypto(9)
BUGSPublic key support is not implemented.
© 2013 Dyxa.com. All Rights Reserved.